Matrice Triebel 6,5 CM

SEATING DIE

The dies contains a lower movable spring-loaded part that smoothy guides the bullet to the die and ensures perfect aligment.

For better accuracy you can achieve when seating bullet by replacing the seating stem, which is screwed diectly in to the seating mandrel.

It is possible to order a seating stem exactly for your bullet. 

When i measuring OAL bullets is good to have  this part for better seating accuraccy.

FUlL-LENGHTH SIZING DIE

FL - die consist of a die body and decapping pin, which can be replaced by an expander unit, if you want. The dies also contain a vent hole, which can be found in the shoulder area, which  helps to reduce the resistance when your formatting the brass and the drain excess lubricant, when you over-lubricate the brass

In the basic set you will find expander in .dia 262 "

When I used wirh Starline brass, I got the NECK TENSION 0,003". 

I set the die to the so-called BUMP 0,002".

That is, the difference in lenght on the shoulders of the brass after formatting. Repeatedly 0,002".

The following setup was used for the test:

Rifle BERGARA HMR 6,5 CM

Barrel length 24"

Silencer A-tec optima 45

Riflescope Vortex PST gen II 5-25x50 FFP EBR-7C MRAD

Leupold QRW rings

                 Tested load:

                 Starline brass 6,5 CM LRP

                 Powder RS 60 40,5 gn

                 Primer CCI BR2

                 OAL  72.2 mm

                 Sierra bullet TGK 130 gn